Porsche - Mobile Charging Cable 8A to 16A Blue 240V CEE. Type 2 Plug

Item Description and Specification

Type 2 to 16A CEE Plug Mobile Charging Cable Suitable For Porsche EV

Type 2 Porsche compatible portable charger that will charge your Porsche PHEV/BEV using a 1 Phase 16A Blue 3 pin CEE plug, the type you will find at industrial units and campsites. Our Porsche portable chargers (also known as a mobile charging cable or granny cable) are suitable for charging your Porsche electric vehicle / hybrid / PHEV anywhere there is a 3 pin 16A 230V CEE socket. Connect the Type 2 (also known as Mennekes) plug into your Porsche electric vehicle for up to 16 amp charging. These Porsche CEE mobile charging cables are backed by a 1 year warranty. To view all of our Porsche charging cables please visit our Porsche chargers page.

To date, our portable chargers can be used with the following Porsche plug-in vehicles. This list is continually updated so please check your handbook, check that your vehicle socket matches the images above, or contact us if your electric vehicle is not listed:

Porsche 918 Spyder, Porsche Cayenne Hybrid, Porsche Macan, Porsche Panamera Hybrid, Porsche Taycan

This charger has several safeguards for added protection while charging:

  • Overvoltage Protection.
  • Device PCB Overheat Protection.
  • Lightning Protection.
  • Overcurrent Protection
  • Water Resistant.
  • Earth Fault Protection

The 3 pin CEE plug portable / home charger can be used in any country that supports the 3 pin CEE plug. This portable charger is not manufactured by Porsche. Please refer to your vehicle handbook for information about charging your vehicle. Charging your Porsche vehicle using a Type 2 to 3 pin Commando socket charging cable may cause a high load on the mains circuit if it is shared by other appliances. Please ensure that the socket where you charge your vehicle is certified by a qualified electrician to ensure that the power outlet and circuit is safe for regular EV charging and is protected against the causes of overheating. This charger is manufactured to the IEC 62752 standard with built in 30mA AC detection and 6mA DC detection. This charger can therefore be used with a circuit protected by the minimum Type A or F RCD..

The charger has adjustable current and can charge at 8A, 10A, 13A and 16A. There is also a timer that allows delayed charging from 1 to 10 hours, ideal if you wish to benefit from off peak charging rates. If you are looking for a charger that has both of the blue 230V 16A and 230V 32A CEE plugs as well as a 13A UK plug, please see our Multi adapter EV charger.

Do not plug the charger into an extension cord or adapter. Reasonable care must be taken if the unit is left outside when it is raining. Please ensure that the unit is not left in standing water and the Type 2 plug cap is emptied of any water and replaced after each use. Store the charger in a safe, dry place. Please read the safety information in the user manual included with this charger before using it. If you do not receive this information, please contact us.

Charging cable checklist

To ensure that the cable you purchase is right for you, please read the following checklist:

  • Make sure the charging cable is compatible with your vehicle. The photos at the top of the page show you what the pins in the connectors look like so you can match the cable to your vehicle.
  • Ensure that your CEE socket is 16A. The plug for this charger is not compatible with a 1 Phase 32A CEE socket or a 3 Phase 16A or 32A socket. The information for the socket should indicate 16A and display the voltage between 200V-250V. The socket cover is usually blue.
  • Make sure that the length of the cable is sufficient to reach the charging socket of your vehicle. We recommend allowing at least half a metre so that the cable is not overstretched.

If in doubt, please contact us via our contact page.

If you would like a Mode 3 charger that connects from a charging station to your EV, browse our range of Type 2 charging cables.

For trade enquiries or bulk purchases please contact us for a quote on our Trade Enquiries page.

EVSE Portable Charger Specifications
EV charger type3-pin blue CEE plug to Type 2 (IEC 62196-2) plug
Cable lengths available5M, 8M
IP gradeWaterproof and dust proof to IP55 grade
Rated current16 amps, 1 Phase
Operating voltage110 - 240v
Cable thickness3G 2.5mm2 + 2 x 0.5mm2
CertificationTUV, CE and IEC tested

Write a review

Please login or register to review
  • Brand: Cebea | Weight (KG): 4.00 | Status: Available
    • Free express shipping within UK mainland. We ship via DPD to UK mainland. The majority of parcels arrive the next working day if ordered before 1pm. DPD deliver to some home addresses on a Saturday. You will receive a notification from DPD on the day of the delivery.
    • Shipping costs may apply for deliveries to the Highlands and UK islands.
    • Cable bag included with every charging cable purchased.

Click Option(s) Below & Add To Basket

  • Ex VAT:
  • £190.00
  • | Inc VAT: £228.00
Useful Links
Free EV Cable Carrier Case