Type 1 to Type 2 EV Charging Cable 32A For Charging Station / Wall Charger

Type 1 to Type 2 32A EV charger - SAE J1772 to 62196-2

Type 1 to Type 2 Mode 3, Level 2 EV charging cable to connect your hybrid vehicle or electric car, motorbike or van to an EV charging station or to a charging point installed at your home or office. The Type 1 Female plug fits into your vehicle and the Type 2 Male plug fits into the charging unit. We supply quality EV charger cables for all electric vehicle types and are available to buy with a 2 year warranty.

• Mode 3 EV charging cable compatible with 16A and 32A EV and hybrid vehicles.
• Ergonomically designed, secure locking plugs.
• CE , TUV, UL standard tested and approved.

If you buy a 32A charging cable, even though your electric car is 16A, then it will also be compatible with charging 7kw 32A electric vehicles.

This Type 1 to Type 2 32A EV Charging Cable & Plugs will be compatible with home/office charging units and the public charging stations you will find at service stations and on the street, i.e Mode 3 Type 2 sockets. Please note that these charging cables cannot be used to adapt or extend an existing charging cable.

Please check your vehicle handbook to ensure that the cable is suitable to use. If you are unsure which plug type is required for charging your electric vehicle, then please use Find My EV Charger and select the make of your electric vehicle. This will also help you to see if other EV chargers such as 3 Phase charging cables and portable chargers are suitable for your EV.

Charging cable checklist

To ensure that the cable you purchase is right for you, please read the following checklist:

• Verify that the charging cable is compatible with your EV. The photos at the top of the page show you what the pins in the connectors look like so you can match the cable plug to your vehicle socket.
• This cable cannot be used to adapt or extend an existing charging cable. If a charging cable is already connected to a charging point, then this cable cannot be used to extend the length by daisy-chaining them together. The cable can only be used with the open socket of a charging point.
• Make sure that the length of the charging cable is suitable for your charging requirements. If you are using a public charging station, we recommend a length of 5 meters as it is not always possible to park so that the vehicle socket is near side to the charging station. If you are using the cable with a wall charger at home or at an office, measure the length required to reach the vehicle socket. We advise allowing an additional half meter of slack to prevent the cable from being overstretched or lifted from the ground, reducing the risk of it becoming a potential tripping hazard.
• If you do not have your electric vehicle yet, please check with the manufacturer or dealer / seller to confirm if it is already equipped with a charging cable.
• This charging cable is compatible with AC charging stations commonly found in supermarkets, retail parks, on the street, and wall chargers typically installed outside a home or office. It is not a DC fast charging cable, also known as CCS and CHAdeMO. You do not need to buy a cable to use fast charging stations, as they are already connected to the charging station.

If in doubt, please contact us via our contact page.

We recommend hi-vis green cables. When charging at public charging points, EV charging cables can pose a potential obstacle, especially in low-light conditions. Exercise caution when leaving your cable unattended. Opting for our green standard charging cables can enhance visibility, minimising the risk of accidents.

This Type 1 to Type 2 32A EV cable is compatible with the on-board charging capacity of most 3KW and 7KW electric vehicles. In the case of 16A vehicles, the cable will discharge the lower current required by your EV. Use our Find My EV Charger page to locate your vehicle and check to see if the 32A cable is available to buy. Please always consult your vehicle manual to make sure that you do not require a specific 32A cable with your EV.

If you would like an EV charger to plug in to a domestic or industrial socket please browse our range of CEE and 3 pin portable EV chargers.

For trade enquiries or bulk purchases please contact us for a quote on our Trade Enquiries page.

Please use the rubber cover for your connectors when not in use and store the charging cable in a dry place. The EV connector plug can collect moisture and it will not work if it senses moisture.