Type 1 EVSE 3 Pin Charging Cable / Mains charger 10A UK Plug

Item Description and Specification

Type 1 Plug (J1772) EVSE 3 Pin Portable Charger 10 Amp

Charge your electric vehicle at your home, office or anywhere that has a 13A 3 pin Type G plug socket (BS 1363) with our type 1 granny cable. Our granny cables (also known as a portable charger or home charger) are compatible with hybrid and electric vehicles, charging at a maximum capacity of 10 amps. Just plug the 3 pin plug into a 13 amp 3 pin socket and plug the Type 1 J1772 charging plug into the socket of your PHEV / BEV. Our home chargers are backed by a 1 year warranty. Should you need the Type 2 version of this home charger then please go to our Type 2 home charger with 3 pin Type G (UK) plug.

The portable charger has several safeguards for added protection while charging:

  • Overvoltage Protection.
  • Device PCB Overheat Protection.
  • Lightning Protection.
  • Overcurrent Protection
  • Water Resistant.
  • Earth Fault Protection

The 3 pin charging cable can be used in any country that supports the 3 pin plug. Please read your manufacturer handbook to check whether you should be using a specific charger with your vehicle. Charging your Type 1 socket vehicle using a 3 pin charging cable may cause a high load on the mains circuit if it is shared by other appliances. 3 pin chargers are therefore recommended for occasional use due to the increased risk of thermal damage caused by continuous loads at 10A.

Why do most 3 pin chargers only charge at 10A?

When charging your EV using a 13A socket, a safety limit of 10A is imposed. While a 3 pin socket can handle a maximum current of 13A, the average 13A socket is designed to endure this level of current for only short periods of time. The 3 pin charger is the slowest EV charging method, necessitating several hours of charging that inevitably subjects the socket to significant heat stress. As a consequence, charging your vehicle with 13A instead of 10A is more likely to lead to thermal damage to both the plug and socket.

The established safe practice for charging an EV with a household or any 13A 3-pin socket is to charge within the range of 6A to 10A. 3 pin chargers are available with the capability to charge at 13A. Despite the slightly faster charging rate offered by a 3 pin 13A charger, we choose not to sell them due to safety concerns. Even charging at 10A carries a risk of thermal damage, especially if the EV is being charged over long durations. Unless an electrician certifies that the socket and circuit are suitable for regular 10A charging, we recommend our Type 2 to 3 pin adjustable amp charging cable. A 3 pin charging cable supporting 6A and 8A is also considered safer for temporary use with 3 pin sockets that have not been tested by an electrician. This choice significantly reduces the risk of damage when charging your vehicle, whether on holiday or using the household socket of a family or friend.

Before charging your vehicle with a 3-pin charger, it is important to have a qualified electrician inspect the 13A socket and electrical circuit to certify its suitability for prolonged use at 10A. This ensures that the power outlet intended for regular EV charging is suitable and is safeguarded against potential overheating issues. Do not plug the charger into an extension cord or adapter. If the unit is left outdoors in the rain, exercise caution and make sure it is not placed in standing water.

Please read the safety information in the user manual included with this charger before using it. If you do not receive this information, please contact us.

Charging cable checklist

To ensure that the cable you purchase is right for you, please read the following checklist:

  • Make sure the charging cable is compatible with your vehicle. The photos at the top of the page show you what the pins in the connectors look like so you can match the cable to your vehicle.
  • Make sure that the length of the cable is sufficient to reach the charging socket of your vehicle. We recommend allowing at least half a metre so that the cable is not overstretched.
  • If you do not have your electric vehicle yet, please check with the manufacturer or dealer / seller to confirm if it is already equipped with a 3 pin charging cable.
  • Please check with your manufacturer or dealer to confirm that a Fixed Amp charger is suitable for your vehicle. Your dealer may recommend that your EV needs a charging cable that can adjust the charging current. We stock charging cables that can vary the current if this is the case.

If in doubt, please contact us via our contact page.

If you would like a Mode 3 charger that connects from a charging station to your EV, browse our range of Type 1 charging cables.

For trade enquiries or bulk purchases please contact us for a quote on our Trade Enquiries page.

EVSE Portable Charger Specifications
Portable charger type3-pin plug to Type 1 (SAE J1772) plug
Cable lengths available5M, 8M
IP gradeWaterproof and dust proof to IP55 grade
Rated current10 amps
Operating voltage110 - 240v
Cable thickness3G 2.5mm2 + 2 x 0.5mm2
CertificationTUV, CE certified
 
List of compatible Type 1 EV's

This Type 1 to Type 2 charging cable is compatible with the following EV's

ChevroletChevrolet Volt
CitroenCitroen Berlingo, Citroen C-Zero
FiskerFisker EMotion
FiatFiat 500e
FordFord C-Max, Ford Focus Electric
HondaHonda Accord
KiaKia Soul 2017-2019
MitsubishiMitsubishi i-Miev, Mitsubishi Outlander
NissanNissan Leaf (Nissan Leaf models manufactured on and before 2017), Nissan NV200
VauxhallVauxhall Ampera
PeugeotPeugeot Ion, Peugeot Partner Van
RenaultRenault Fluence, Renault Kangoo T1, Renault Kangoo ZE T1
TataTata Indica, Tata Tigor
ToyotaToyota Prius (Toyota Prius models manufactured on and before 2016)

Please contact us if your vehicle is not listed or match your vehicle socket to the photos above.

Please check that the charging socket of your motorcycle matches the photos above to confirm that this charging cable is compatible.

BMW MotorradBMW C Evolution
Energica MotorradEnergica Eva, Energica Ego
Victory MotorradVictory Empulse TT

Write a review

Please login or register to review
  • Brand: Duosida | Weight (KG): 3.00 | Status: Available
    • Free express shipping within UK mainland. We ship via DPD to UK mainland. The majority of parcels arrive the next working day if ordered before 1pm. DPD deliver to some home addresses on a Saturday. You will receive a notification from DPD on the day of the delivery.
    • Shipping costs may apply for deliveries to the Highlands and UK islands.
    • Cable bag included with every charging cable purchased.

Click Option(s) Below & Add To Basket

  • Ex VAT:
  • £155.00
  • | Inc VAT: £186.00
Useful Links
Free EV Cable Carrier Case